How To Solve Overload Problems Associated With Cell Signal Boosters?

woman looking at her phone frustrated.

Cell signal boosters provide you a cost- and labor-effective solution for dealing with different problems associated with poor cell reception including dropped calls, slow internet, etc. One of the biggest advantages of these devices is that they can boost the signals from different carriers and multiple towers. Hence, no matter which cell phone network you use, they can be helpful for you. 

However, it does not mean that there are no challenges associated with cellular signal boosters. There are certain problems that can affect the performance of your cell signal boosters. Overload is one among them. Therefore, through this article, we provide you some important information about overload problems and the ways to solve them. 

Overload

This is a problem that is commonly found when your office or home is located in areas where there are strong signals from nearby cell towers. If there are one or more cell towers in close proximity, then it can become too much for your boosters to bear as the strength of the signals will be too high. This can cause your boosters to shut down to save themselves from overload problems. Therefore, it is important to solve this issue for regaining the performance of your signal boosters.

Luckily, you can solve this problem easily using some simple techniques. The following are some important tips that will help you to solve overload problems easily.

How To Troubleshoot Overload Problems?

You can try different techniques for solving overload problems. Some of them are listed below:

Use Directional Antenna

This can be useful for you if you are experiencing overload problems from different cell towers in opposite directions. If another cell tower other than your carrier is creating overload problems, and if the cell tower that creates overload problems is standing in the opposite direction of your carrier tower, then a directional antenna can help you. Directional antennas receive signals only from a 45-degree field. So you can use it for pointing towards the direction of your cell tower so that it will not receive any signals from the opposite tower. 

But this solution is not applicable if both the antennas are standing in the same direction or if the overload problem is caused by your own carrier. 

Use A Filter

Filters can be useful for you to reduce the strength of the signals. They can help to attenuate the strength of the signals received by our boosters. Hence, using a filter can help you to easily avoid overload problems. 

These tips will help you to easily solve overload problems and regain the performance of signal boosters.